Advertisement
REMOVING THE SKI SET
After the Ski kit has been removed and the FirstBIKE reassembled, you may confirm your
child is ready to ride FirstBIKE without the SkiSet. Ensure that your child's feet are firmly
placed on the ground with a slight bend in the knee. For the FirstBIKE with a brake,
ensure that the brake performance is optimal.
1. To remove the rear ski, use the 6 mm hexagonal ("Allen") wrench to loosen the rear
axle nut and bolt and remove the rear ski (Parts A and B).
2. After removing the rear ski assembly parts, cut the tie wrap holding the brake line (if
applicable)
3. To fit the rear wheel, turn the FirstBIKE upside down so that it rests on the seat and
handlebar. Align the frame, wheel and brake assembly (if applicable). Ensure that the
tire rotation arrow matches the driving direction. The recommended/ maximum tire
inflation pressure is 2,5 bar (36,25 PSI) DO NOT OVER INFLATE!
For FirstBIKE with brake,ensure the extruding black "pin" on the brake assembly is firmly
inserted in the "lower" hole (from two holes) of the frame prior to tightening.
4. Tighten the rear wheel nut and bolt securely using the 6 mm hexagon ("Allen")
wrench.
5. To remove the foot pegs use the 4 mm hexagon ("Allen") wrench and remove the two
bolts on either side.
6. To remove the front ski, use the hexagonal ("Allen") wrench to loosen the front axle
nut and bolt and remove the rear ski (Parts A and C).
7. Reassemble the front wheel by re-alligning the frame and wheel assembly.
Tighten the wheel nut and bolt using the 6 mm hexagon ("Allen") wrench.
Advertisement
