Bennett Read SUPERCHEF 10+ User Manual page 9

BEFORE FIRST USE
Remove any packing materials and labels from your electric pressure cooker. Be sure to open the lid
and remove the cooking pot to check for parts that might be stored inside.
Be sure that all of the appliance parts are included and accounted for before you dispose of the packing
materials. You may however store the box and packing materials away to use at a later time.
Before you use your SUPER CHEF 10 PLUS for the rst time, wipe the cooker clean with a damp cloth.
Clean the lid and the removable inner pot. The removable inner pot can be cleaned with warm soapy
water. Do not put the removable pot in the dishwasher. Rinse with clean water, towel dry, and place it
back into the cooker.
The lid seal ring may already be installed on the steam plate, if not, make sure that it is installed
properly on the steam plate.
INSTALLING THE LID SEAL RING ON TO THE STEAM PLATE
Place the lid seal ring around the edge of the steam plate and turn it with your hand to secure it evenly.
NOTE: You can remove and clean the steam plate and lid seal ring after cooking. Follow the steps
below to remove the steam plate and lid seal ring:
Steam plate
Remove the lid from the cooker and turn it upside
down. Gently remove the steam plate from the
underside of the lid as shown above.
Clean the steam plate and lid seal ring with warm soapy water. Make sure that they are completely dry
and correctly assembled before inserting back into the lid. Align the steam plate with the middle support
pin on the underside of the lid and press the steam plate down. After installation, check whether the
gap between the lid seal ring and the perimeter of the lid is even. Make sure it can be turned freely
prior to use. Be careful not to install it upside down (the steam plate does not protrude outward).
Lid seal ring
Remove the lid seal ring from the steam plate as
shown above.
5