Page 1
BC 2011 Dolphin Velocity Hand Dryer User Manual Please read carefully before use...
Page 2
Thank you for purchasing the BC 2011 Dolphin Velocity Hand Dryer. This product adopts CPU control,wide LCD display screen, and is durable and ergonomic. It applies high-speed brushless DC motor to produce jet airflow that dries your hands in 6-12 seconds.
Page 3
Installation for internal circuit lining: 1. Take out the water tank from the bottom ;(Figure 3) 2. Remove the screws by using the screw driver, and then remove the front cover;(Figure 3) 3. Remove the screws , open the cover of the wire box ,remove the power line, put the prepared power down-lead through the middle hole, and connect to the terminal .Please note that do not misconnect L, N and ground;(Figure 3) 4.
Page 4
4. Please clean up the water in the water tank before reach the full-line; clean up the water at least 1 time every week when seldom use the hand dryer. 5. To prevent the drain from being blocked, pour out about 200ml water to the drain, and clean up the water in the water tank.