Advertisement
HC52 Series
CABLE ASSEMBLY INSTRUCTIONS HC52RB-213
All dimensions are in mm [inch]; drawings not to scale
© 2019 hivolt.de - Subject to change without notice, errors expected
hivolt.de GmbH & Co. KG
Oehleckerring 40
D-22419 Hamburg
∙
Step 1: strip as shown.
Step 2: slide ferrule"D" over cable.
Step 3: put and gasket "C"and pin "B" on center conductor
Step 4: loosen braiding and slide connector "A" in place.
Step 5: slide ferrule "D" towards the connector "A" and
Germany
+49 40 537122-0
∙
∙
Make sure not to scratch the isolation!
and solder in "Y".
Gasket must be under compression after soldering
is competed.
crimp.
Use 10.7mm/0.421" hex crimp die insert
HC-CR-DIE-C.
+49 40 537122-99
info@hivolt.de
∙
∙
HC52_E 08/2019 Page 7 of 7
www.hivolt.de
∙
Advertisement
