Kenwood Mini 1150 rapid Operating Instructions Manual page 84

Connection and installation
Attention
• Always ensure the drain hose is free of obstructions of any kind, since this will have an adverse affect
on the smooth running of your machine.
• Only install your machine in a room protected from frost.
• The company excepts no responsibility for improper use, or maintenance work carried out by
unauthorised service personnel resulting in water damage.
84
Drain connection
• Do not kink the drain hose.
• Hang the drain hose over the edge of thge sink or wash basin. The bend in
the hose must not be raised more than 1 m above the surface on which your
machine stands (so that drainage can function properly).
• Secure the drain hose with the hose holder supplied. Pull the hose holder to
the centre of the hose bend onto the drain hose and secure against slipping.
If required, use a weight or any other suitable means to ensure that the drain
hose cannot slip.
• Tight connection to a non-ventilated drain requires special steps and shoulde
carried out by a plumber only.
Setting up and starting
• Ensure the unit is on an even, firm surface.
• All four screw-mounting feet must stand firmly on the floor.
• To set up the machine, adjust one or more of the screw-mounting feet by
loosening the counter-nuts.
• After adjusting the screw-adjustment feet, tighten the relative lock nuts again
in the direction of the arrows (with a SW 17 spanner).
• Turn on the tap and check the run off hose.