Initial Start-Up; Filter Replacement Schedule - TESY AC16EHCI Usage And Storage Instructions

INITIAL START-UP:

EN
1.
Take the Air Cleaner out of its packing.
2. Remove the protection polyethylene envelope above
the granulated active carbon filter (VOC).
3. Ensure that the filters are arranged correctly and check
if all of them are positioned in their place (in accordance
with the filters diagram above).
4. Connect the power cord to an electricity outlet in a
correct manner (Before switching on the appliance ensure
that the technical plate voltage concurs with the voltage
in your electricity system).
5. Press the power button
Press the same button again to turn the air cleaner off.
6. Press the fan button
(Low) > M (Medium) > H (High)
7.
Press the clock button
function: 1 > 2 > 4
The timer-off can be set to 1 – 7 hours. The air cleaner will
automatically turn off after it has been in operation for the
selected hours.
8. Press the ion button
Press the button again to turn this function off.
9. Press the UV button
Press the button again to turn this function off.
10.
The filter indicators will light up when the filters need
to be replaced. After the necessary replacement of filters
hold the filter button
filter indicator shuts off. This will reset the hours of filters
use timer.

FILTER REPLACEMENT SCHEDULE

The usable lifetime of the active carbon pre-filter is 1400
hours and usable life time of the HEPA and the VOC Filter
is 2800 hours, depending on the level of the room's air
contaminants and the frequency of use.
CAUTION: The volume of air to be cleaned will
decrease considerably when the filters need to be
replaced.
We recommend having at hand a spare set of filters
for future replacement and depending on the filter
replacement light indication to replace the filter and
restart the timer of the filter that has been replaced.
Note: Photo catalytic TiO
When a special need occurs to buy a new filter it is
necessary to contact the Service Headquarters in your region
and request a delivery of this filter.
8
Instructions for use and maintenance
to turn the air cleaner on.
to select the fan speed: L
to select the timer-off
to turn on the ionizer function.
to turn on the UV function.
for several seconds until the
filter is not to be replaced.
2
FILTER REPLACEMENT
Filters are specially designed for easy replacement and to
provide maximum performance.
1. When the 'replace filter' light is illuminated, you should
switch the air cleaner off and disconnect the power cord
from the electricity socket.
2. Take the air cleaner and place it on a flat surface with
the appliance in horizontal position.
3. Place one hand on the middle top of the cover, insert
your finger in the slot at the side of the air cleaner and pull
the front cover outwards.
4. Remove and discard used filter/s in a specially
designated location in your neighborhood.
5. Remove any plastic protective wrapping and
packaging from the new filter/s.
6.
Put the new filter/s into the air cleaner (in accordance
with the filter diagram above).
7. Install the Front Grille by engaging its tabs into the
bottom slots on the unit. Then swing the grille up and
gently press on the top to snap into place.
CAUTION: Ensure that the filters are arranged
correctly and check if all the filters are in their place
before connecting the power plug to the socket.
8. Plug the air cleaner into an outlet for operation.
9. After replacing the filter/s push and hold button
3 seconds to reset the filters use timer.
Note: HEPA and VOC filters are to be replaced at the
same time when the filter check light illuminates!
1. Tab 2. Filters
for
5. Press
on top
cover.
4. Pull
outwards.
3. Slots