GMC Chevrolet Camaro Owner's Manual page 162

3. Remove the calipers (3) from
the knuckle.
4. Remove the brake rotors (2).
5. Remove the original front
splash shields (1).
6. Remove the lower control arm
deflectors.
7. Detach the wheel speed
sensor harness clips from the
lower control arm deflector.
8. Install the small splash shields
with two screws (2) per corner.
Torque to 9 Y (80 lb inch).
Caution
Failure to reattach the wheel
speed sensor harness clips
correctly could cause interference
with the wheel speed sensor, and
could damage the vehicle.
9. Re-attach the wheel speed
sensor harness clips by
pushing them from the bottom
Driving and Operating
up, on the back tab. On the
original deflector, the push pins
are pushed from the top down.
10. Install the tall deflectors with
three screws (1) per corner.
Torque to 3.3 Y (29 lb inch).
When installing new control
arms, torque the three screws
to 4.5 Y (40 lb inch).
11. Install the front rotors with one
screw per corner. Torque to
9 Y (80 lb inch).
12. Apply liquid thread adhesive to
the caliper bolts (GM Part No.
9985399 Loctite 272
161