GMC Chevrolet Camaro Owner's Manual page 14

3. Remove the key lock cylinder
cap on the driver door handle.
See Door Locks 0 18. Insert
the vehicle key of the new
transmitter into the key lock
cylinder on the driver door
handle and turn the key to the
unlock position five times within
10 seconds.
4. The DIC displays READY FOR
REMOTE #3, 4 or 5, 6,7, or 8.
5. Replace the recognized
transmitters with a new
transmitter. Place the new
transmitter in the rear
cupholder in the center
console.
6. Press ENGINE START/STOP.
When the transmitter is
learned, the DIC will show that
it is ready to program the next
transmitter.
7. Remove the transmitter from
the cupholder and press
or .
To program additional
transmitters, repeat Steps 3 5.
When all additional transmitters
are programmed, press and
hold ENGINE START/STOP for
12 seconds to exit
programming mode.
8. Put the key back into the
transmitter.
9. Replace the key lock cylinder
cap on the driver door handle.
See Door Locks 0 18.
Keys, Doors, and Windows
Programming without Recognized
Transmitters
If two currently recognized
transmitters are not available, follow
this procedure to program up to
eight transmitters. This feature is
not available in Canada. This
procedure will take approximately
30 minutes to complete. The vehicle
must be off and all of the
transmitters to be programmed must
be with you.
1. Remove the key from the RKE
transmitter.
2. Remove the key lock cylinder
cap on the driver door handle.
See Door Locks 0 18. Insert
the vehicle key of the
transmitter into the key lock
cylinder on the driver door
handle and turn the key to the
unlock position five times within
10 seconds.
The DIC displays REMOTE
LEARN PENDING,
PLEASE WAIT.
13