BURG-WACHTER PointSafe Operating Instructions

OPERATING INSTRUCTIONS
FOR USE OF POINT SAFE WITH
DIGITAL LOCK
BURG-WÄCHTER KG
Altenhofer Weg 15
58300 Wetter
Germany
www.burg-waechter.de
Point Safe < 03-2006
IMPORTANT ADVICE
• Please keep your codes and emergency keys in a
safe place – but not in the safe!
• Do not use any personal dates (e.g. birthday,
telephone no. ....)
• If the safe is unlikely to be used for a long time,
remove batteries.
• For hotels: See text below on the right hand side
and attached guest code instructions.
• For your own security, change both master code
and user code from their factory settings.
• If further advice is required, please contact your
local retailer or Security Centre.
USING YOUR POINT SAFE FOR THE FIRST TIME
Slide cover plate marked 'Point Safe' away from
keypad to the right hand side in order to reveal the
keyhole.
Turn the key clockwise until the stop. The door opens
automatically. Turn the key back anti-clockwise – the
bolts will extend again – and remove the key. Remove
the battery cover on the inside of the door. Insert 5
batteries LR6/AA/1.5V/Alkaline.
ATTENTION: When new batteries are required the
LCD display shows 'LO BATT'. All 5 batteries have to
be replaced then. Please see that the batteries will be
disposed ecofriendly.
OPENING OF THE SAFE
Press the "Enter" button. Enter the user code
(factory code 168) and press the "Enter" button.
The door opens automatically.
CLOSING THE SAFE
The door will close automatically when the "Close"
button is pressed.
ATTENTION: In case the door is blocked by an
obstacle, the LCD will display "BLOCK". The safe
cannot be closed then. Remove the obstacle and try
again.

CHANGING TO A NEW USER CODE

The door has to be open and the bolts have to be
engaged. Press the "Enter" button, the LCD will
display "Code", enter the new user code (1- max.
6 digits), press the "Enter" button and then the
"Close" button. The door closes automatically.

INCORRECT CODES

In a closed state the safe will not accept any incorrect
codes. In such a case the LCD will show "ERROR"
and short tones can be heard. If an incorrect code is
entered three times the electronic will block the safe
for 5 minutes.
Once this period has passed the safe can be opened
with the master code as well as with the correct
user code. If an incorrect digit has been entered by
mistake it can be deleted by pressing the "Close"
button.
1 1