Installation; Remote Control - BASETech 1516850 Operating Instructions Manual

8. Installation

• Choose a suitable installation spot.
• Pull apart the air outlet hose by pulling slightly on both ends.
• Screw both adapters clockwise onto the ends of the air outlet hose.
• Place the window mount into the window. The circular opening must face inward.
The window mount is designed exclusively for use with sliding windows (horizontal + vertical).
The length of the window mount is min. 67.5 cm and max. 123 cm.
• Close the window as far as possible to fasten the window mount.
• Install the air outlet hose adapter (5) on the back of the product. The oblong bracket on the left side of the adapter
fits into the oblong opening. Slide the adapter down to secure the connection.
• Pull apart the air outlet hose to the required length.
Guide the exhaust hose as straight as possible during installation. Do not bend the exhaust hose.
• Attach the other end of the air outlet hose to the opening on the window mount. The adapter clicks into place.
You may also guide the exhaust hose through the window without using a window mount. Close the window
as tight as possible. Make sure not to squeeze the hose or hence damaging it.

9. Remote control

• Remove the battery compartment lid.
• Insert 2 AAA batteries and heed correct polarity. Heed correct polarity as indicated in the battery compartment.
• Close the battery compartment.
Change the batteries when the product no longer responds to commands from the remote control.
Always point the remote control at the IR receiver below the display.
The button with no label has no function.
20