Saga DCP Series User Instruction

Ver. 7.0
You could enter into the programing mode to re-set the function code. To use and program the hotel
safe, please kindly read and follow the instructions carefully:
:

Important Tips

The digital in every position indicate the different function.If you wouldn't like to change the current
setup,you only need to input the same digital in corresponding position or press
into the next screen till quit .
Once you changed their setup ,please press the key
programming mode.
Door position: OPEN (initial code is
＊＊"
key in " ,the hotel safe LED will show
seconds after "PROG" disappeared. Now the operation screen starts to enter into programming mode
(input key "#" again,you will enter into the second screen)

Program Mode

First Screen
The Options:
(1) CODE APPEARANCE ON THE SCREEN
Press 0 – The presonal code number will not appear on the screen each time when you input the code
(namely is the screen just shows "--------" instead of digit code when you input the code to
open or close the door )
Press 1 -The personal code number will appeared each time.
"#"
1234 ; initial master code is
"PROG ", then input the programming code "751019"in 5
to save the latest setup when quit the
000000 )
Default Parameter
"#"
to enter
SAGA