Advertisement
6. troUblesHootinG
A) motor operates but
1. Water level below min suction depth.
there is no suction.
2. Air bubbles in pump accumulated during submersion,
or float is incorrectly positioned so that pump does not
stop at minnimum level and sucks in air.
3. Clogged intake or discharge pipe.
B) Reduced water
1. discharge pipe too narrow.
volume for level
of water.
C) The pump will
1. no electrical power.
not start or suddenly
2. Float not working.
stops.
environment protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
weee reGUlations
dispose of this product at the end of its working life in compliance with the eU directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
warranty: guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, Kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
1. Stop the pump.
2. Release air by inclining the pump and re-immersing
it in water.
3. Remove blockage, and clean the unit.
1. Use wider diameter pipe.
1. Check cable, plug and fuse.
2. Contact authorised service agent.
www.sealey.co.uk
WPl117A | Issue 3(H) 20/03/18
Advertisement
