Advertisement
Quick Links
Assembly, Operation & Maintenance Instructions
EBCIM17 NEO Built-In Module for
NEO Bevarage Cooler NBC208SS
NEO Outdoor Kitchen - For outdoor use only
IMPORTANT
PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE.
THIS IS IMPORTANT INFORMATION REGARDING THE
USE AND CARE OF YOUR BARBECUE
September 2020
Assembly, Operation & Maintenence Instructions
Page 1
Advertisement
Summary of Contents for Kettler neo EBCIM17
- Page 1 Assembly, Operation & Maintenance Instructions EBCIM17 NEO Built-In Module for NEO Bevarage Cooler NBC208SS NEO Outdoor Kitchen - For outdoor use only IMPORTANT PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE. THIS IS IMPORTANT INFORMATION REGARDING THE USE AND CARE OF YOUR BARBECUE September 2020 Assembly, Operation &...
- Page 2 It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Kettler reserves the right to alter specifications or appearances without notice. Dispose of packaging responsibly – recycle where facilities are available.
-
Page 3: Important Safety Instructions
Important Safety Instructions Important Read the assembly instruction section and safety precautions of this booklet carefully before removing the contents of this carton. If you are unsure about anything regarding your built-in module or beverage cooler, please contact your Service Centre before operating the appliance. 1. - Page 4 Remove all components from the cartons and carefully check against Parts List. Make sure you thoroughly inspect parts before assembly. Some assembly will require the use of a Phillips Drive screwdriver. Kettler recommends that the assembly be done by 2 (or more) people due to the size and weights of the components.
- Page 5 Step 1 Place rear panel (04) on the ground and right panel (03) up against it so that the screw brackets match up with the screw holes. Fix in place using 2 butterfly screws (7). Note orientation of power cable hole. Step 2 Repeat step 1 using the left panel (02).
- Page 6 Step 3 Place the front support (05) at the front top of the module between the left and right panels, so the overhang matches up with the side strips and the screw holes match up. Use 4 M4 screws (06) to fix it in place. Step 4 Carefully lift the top panel (1) and place it centrally...
- Page 7 Step 5 The module is now finished. Carefully move it close to the final position, and then pass the beverage cooler power cord through the hole at the rear of the module. While supporting the power cord, move the module to its final position. Carefully position the beverage cooler centrally inside the module and follow start-up instructions for the beverage cooler.
-
Page 8: For Your Safety
• Damaged components may endanger your safety or shorten the life of the product. Replace all damaged parts immediately. Use only spare parts manufactured by Kettler. Should you wish to purchase spare parts, they can be ordered directly from: www.kettler.co.uk/shop •...