Flex PS 10.8/18.0 Original Operating Instructions page 15

429716_Akku-Adapter PS.book Seite 15 Mittwoch, 1. Juli 2015 7:45 07
PS 10.8/18.0
Battery state of charge
Press the button on the battery to check the
battery state of charge at the state of charge
indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after
the button is pressed, the battery is faulty and
must be replaced.
Connecting external consumers
It is possible to connect external consumers to
the USB ports and the DC connecting socket
at the same time. The number of connected
consumers affects the operating time of the
battery in use.
The electronic circuitry of the battery adapter
prevents the battery in use from being
overloaded.
NOTE
The rated power of the two USB ports is 7.5 W
in total. When both USB ports are being used,
in each case only 3.75 W is available.
The connected loads of conventional
consumers are:
– Heated jacket TJ . . . . . . . . . . . . .12 W
– Mobile phone, smartphone . . . .2.5-5 W
– Tablet PC . . . . . . . . . . . . . . . .7.5-10 W
CAUTION!
Always insert plugs fully into the respective
sockets/ports. Danger of device damage!
Power saving mode
If a battery is connected to the adapter for an
extended period of time (> 14 days), the
power saving mode is activated. Power is no
longer applied at the outputs. To deactivate
the power saving mode:
Remove the battery from the adapter and
then reinsert.
15