Table of Contents
Advertisement
Rev. 1.0
3 Transport
3.1 Packaging
The type of packaging depends on the individual mode of shipping. If not separately contracted, the
packaging is in accordance with the rules and regulations of Walther Systemtechnik GmbH. This rule is in
accordance with the Federal Association for Packaging HPE.
3.2 Tasks before Transport
The following has to be done before transport:
Disconnect all power lines.
The actual transport of the incomplete device and its individual parts requires special care in order to prevent
damages from external forceful impact or careless on- and off-loading. Depending on the mode of
transportation, suitable transport and load securing has to be selected. The incomplete device will be aligned
and leveled by appropriate fastening elements
4 Functional description
The SMS-17 Handpen is controlled via a mechanical manual lever. The medium is supplied from a pressure
tank or via a feed pump. The separately controlled spraying air atomizes the material into a spray jet.
Depending on the air cap used, this valve sprays in flat- or round spray
4.1 Function
CAUTION
Use of other media can result in malfunctions, property damage, or destruction of the
machine
The SMS-17 Handpen is particularly designed for a very fine application of low-viscosity media such as
colors or release agents in plastic moulds. Depending on the viscosity of the medium, the application pattern
can be adjusted individually via nozzle dimension, atomizing air pressure and material pressure. The supply
of atomizing air, control air, and material takes place via two hoses. The SMS-17 Handpen is a high-precision
tool. Always keep clean and observe minimum instructions to maintain a long life of the valve.
Assembly Instructions - Handpen SMS-17
.
Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
Page 6 of 16
Advertisement
Table of Contents
