Table of Contents
Advertisement
Available languages
Available languages
12 www.electrolux.com
Problem
The compressor
does not start im-
mediately after
pressing the
Schnellkühlen but-
ton, or after chang-
ing the temperature.
Water flows on the
rear plate of the re-
frigerator.
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
6.1 Replacing the lamp
1
6.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
Possible cause
The compressor starts af-
ter a period of time.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
Schnellkühlen function
switched on.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
2
Solution
This is correct.
This is correct.
Switch off Schnellkühlen
manually, or wait to set the
temperature until the func-
tion has reset automatically.
Refer to " Schnellkühlen
function".
Set a higher/lower tempera-
ture.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
1.
Switch off the appliance.
2.
Press on the rear hook and at the
same time slide the cover in the direc-
tion of the arrow.
3.
Replace the lamp with one of the
same power and specifically designed
for household appliances. (the maxi-
mum power is shown on the lamp
cover).
4.
Slide the lamp cover into its original
position.
5.
Switch on the appliance.
6.
Open the door. Make sure that the
light comes on.
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Advertisement
Chapters
Table of Contents
