Viessmann H0 6723 Operation Manual page 3

1. Important information
Please read this manual completely and attentively before us-
ing the product for the first time. Keep this manual. It is part of
the product.
1.1 Safety instructions
Caution:
Risk of injury!
Due to the detailed reproduction of the original and the intend-
ed use, this product can have peaks, edges and breakable
parts. Tools are required for installation.
Electrical hazard!
Never put the connecting wires into a power socket!
Regularly examine the transformer for damage. In case of
any damage, do not use the transformer!
Make sure that the power supply is switched off when you
mount the device and connect the cables!
Only use VDE/EN tested special model train transformers
for the power supply!
The power sources must be protected to prevent the risk of
burning cables.
1.2 Using the product for its correct purpose
This product is intended:
- For installation in model train layouts and dioramas.
- For connection to an authorized model train transformer
(e. g. item 5200).
- For operation in dry rooms only.
Using the product for any other purpose is not approved and is
considered inappropriate. The manufacturer is not responsible
for any damage resulting from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
- 2 LEDs with connection cables
- 2 heat shrink tubes
- 2 lamp shades
- 2 lamp glasses
- Lamp mast
- Base socket
- Resistor (multi-coloured rings)
- Diode (single ring)
- Manual
2. Introduction
This lamp produces light by SMD-LEDs which is suitable to the
lamp model. Low heat build-up and power input. Nearly unlimit-
ed lifetime of the LEDs, so no more change is required.
3. Assembly
- See page 2 chapter 3. "Zusammenbau/Assembly".
4
EN
4. Mounting
- Check function before mounting.
- Drill a hole (H0: Ø 6 mm, TT, N: Ø 3,5 mm) at the mounting
place (fig. 1).
- Put the base socket with the cables from above through the
hole.
Caution:
Never touch the mast but only the patented base socket (fig. 3).
When connecting the cables, please leave a loop of approx.
2 – 3 cm behind the lamp, which enables you to pull the lamp
out of the assembly drilling.
Caution:
Resistor and diode at the cables are needed for proper func-
tion of the lamp. Never cut them off! Never cover resistor or
diode with insulation material, because they have to be cooled
by surrounding air!
5. Connection
Connect the LED lamp to the light output of a model train trans-
former (e. g. item 5200) as shown in fig. 4 and/or 5.
DC voltage: Connect the diode with the positive pole and the
resistor with the negative pole of the power supply.
AC voltage: Operation with AC voltage could cause some flick-
ering. We recommend to use the Viessmann power module
item 5215 (fig. 5) which is sufficient for approx. 100 LED lamps
or reflectors. Connect the cable with the diode to the brown out-
put socket and the cable with the resistor to the red output sock-
et (fig. 4).
6. Technical data
Operating voltage:
(with and without 5215 power module)
Operating current:
10 – 16 V AC ~
14 – 24 V DC =
13 – 24 V digital signal
ca. 10 mA
5