Modes - 3Com OfficeConnect Wireless 54Mbps Quick Start Manual

2

Modes

Reset Button This button has 2 functions:
■
■
Ethernet Port Connect the LAN cable here.
■
■
Power Connect the supplied power adapter here.
Your 3Com OfficeConnect Wireless 54Mbps 11g Travel Router has four
modes:
Setup/Configuration Mode — used for configuration only.
■
AP (Access Point) Mode.
■
Router Mode
■
Client Mode — Allows a device with an Ethernet port to connect to a
■
wireless network.
The mode is set ONLY by the mode selector switch on the side of the
Travel Router. (You will need to wait a few seconds after changing
modes.)
It is important to understand these different modes, and the benefits of
each.
Setup/Configuration Mode
Use this mode to perform initial configuration of the Travel Router or to
perform any required configuration changes. In Setup/Configuration
mode, the following settings are always used.
User name admin
Password The current password is used. Default password is blank.
IP address 192.168.0.1 (Mask: 255.255.255.0)
DHCP Server Enabled (for both Ethernet & Wireless)
SSID 3Com is the default name.
Wireless Security Disabled
Press & release - restart (reboot)
Press & hold (for 5 seconds) while
powering on - reset all settings to factory
defaults.
In AP mode or Router mode, this is
connected to the LAN or WAN (Cable/DSL
modem).
In Client mode, this is connected to your
PC.