Safety Instructions - phytron LSS 26 Manual

How to Handle In-Vacuum and Cryo Stepper Motors

1.2 Safety Instructions

Intended use:
i
The In-Vacuum and Cryo stepper motors are designed for operating in an
in-vacuum drive system.
- An installation is allowed only if the requirements of the EC Ma-
chinery and EMC Directives are conformed with.
Part of a machine:
i
This product is used as a part of a complete system, therefore risk evalua-
tions concerning the specific application must be made before using the
product.
- Safety measures have to be taken according to the results and be
verified.
- Personnel safety must be ensured by the concept of this overall
system (e.g. machine concept).
WARNING – Injury from the rotating shaft!
The rotating motor shaft can accelerate loosely attached parts. This can
result in injury.
- Make sure, that before operation, all moving parts are fixed.
WARNING – Injury from the rotating shaft!
Hair, clothes and jewellery can be wound up and trapped by the rotating motor shaft.
- Before starting to wire, make sure that clothing and jewellery are
tight and hair cannot be captured.
WARNING – Injury from conversion into a translational motion!
If the rotation in the customer system is converted into a translational motion
(e.g. via spindle) injuries can occur from crushing.
- Before operation, check the system structure.
WARNING – Serious injury from electric shock!
During electrical installation cables, connectors, etc. can be live.
- Do not plug or unplug the motor while powered.
- Do not plug or unplug the connectors while powered.
- If the motor was energised, wait 3 minutes after power off to allow
the capacitors to discharge and ensure that there are no residual
charges on cables, connectors and boards.
6 MA 1203-A010 EN