Step 5: Initiate Module Setup - Delphi Connect Manual

Table of Contents

Advertisement

Step 5: Initiate Module Setup

Stop!
Do not proceed until the Status LED is solid
blue, indicating activation on the Verizon network.
• Insert your vehicle's ignition key and turn it
to the on position (not ACC/Accessory).
not start the engine!
- Typically, all of the warning lamps on the
dashboard will illuminate briefly in this position
- For pushbutton-start vehicles, the procedure is
typically to push the start button without your
foot on the brake (check your vehicle owner's
manual to determine how many presses are
required to turn the ignition on).
• Press and hold the Function Button on the side of
the module until the Status LED blinks red one
time. This will occur after approximately
5 seconds. Then release the Function Button. The
LED will blink red while vehicle setup occurs.
• Wait up to 30 seconds for the LED to display a mix
of solid and blinking green.
Do
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Connect and is the answer not in the manual?

Table of Contents