Advertisement
PRINT AdJUSTMENT
1.
Print location is correct when extreme righthand and
lefthand characters are located as shown.
Approx. 1/16 inch (1.6 mm)
FEED GUIDE
Figure 9
3. Push feedwheel button in completely and turn
slightly clockwise if print is too far left or slightly
counterclockwise if print is too far right. Adjustments
made without completely depressing button are
temporary.
4. Repeat steps 2 and 3 until print is correctly
located.
REMOVING SUPPLIES
TEAR
Figure 10
Figure 11
TEAR
BACKING
PAPER
LABEL
STRIP
PAGE 2 OF 3
INSTRUCTIONS CONTINUED
31-0293
SALE
$9
99
6
Approx. 1/16 inch (1.6 mm)
2.
Place small coin in
feedwheel button slot.
(See Figure 9)
1.
Tear label strip at label
roll as shown and pull
label roll from between
hubs. (See Figure 10)
2.
Tear backing paper
strip. Pull label strip
from labeler. (See
Figure 11)
3.
Squeeze and release
operating lever until
backing paper is free
to be pulled out.
(See Figure 11)
CLEARING JAMS, CLEANING ANd LUbRICATION
Figure 12
BRAKE
WHEELS
REMOVAL
STRIP
FRONT
EXIT
2. Clear label track by squeezing trigger and feeding
label removal strip under brake wheels and out front
of labeler. (See Figure 12)
END OF
TRACK
Figure 13
4. If adhesive buildup occurs, lubricate with one drop
of a commercial 100% silicone lubricant as shown
with labels loaded.
Figure 14
LUBRICATE
Figure 15
LUBRICATE
NOTE: DO NOT OVER LUBRICATE!
1.
With label roll removed,
check label track and
backing paper track
for stray labels.
3.
To clear backing paper
track:
a. Insert label removal
strip in end of track
to loosen stray
labels. (See Figure
13)
b. Insert label removal
strip as shown,
using corner to
remove stray labels.
(See Figure 13)
LUBRICATE
One drop each side of
label chute between
spring and backing
paper. (See Figure 14)
LUBRICATE
One drop each spot
on backing paper
(total of four drops).
Spread with finger.
(See Figure 15)
0712 IH-708
Advertisement
