Jeep Renegade Owner's Handbook Manual page 49

40
Button B fig. 40: Briefly press button B
will open the sunshade blind in "steps".
Pressing the button for longer, instead,
will activate "continuous automatic"
opening. Briefly pulling the button will
give a "snap" closing of the sunshade
blind. Keeping the button pulled,
instead, will activate "continuous
automatic" closing.
Button C fig. 40: press and release the
button to move the roof to the "spoiler"
position (swivel opening). This type of
swivel opening can be activated
irrespective of the position of the
sunroof. During "spoiler" opening, any
pressure on button C stops the roof
closing. Press button C with the roof fully
closed to open the roof to the "swivel"
position. If the roof is positioned between
the fully open position and the "swivel"
position, press button C to close it
manually.
ANTI-PINCH DEVICE
The sun roof and the electric blind are
equipped with an anti-pinch safety
system capable of detecting the presence
of an obstacle whilst the roof is closing:
if this happens, the system intervenes
and the movement of the glass is
immediately reversed.
J0A0224C
EMERGENCY OPERATION
If the control buttons fail to operate, the
sun blind and the sun roof can be moved
manually, proceeding as described
below:
Sun blind movement: remove protective
cap A fig. 41 on the internal trim;
Sun roof movement: remove protective
cap B on the internal trim;
41
take the supplied spanner C from the
luggage compartment;
insert key C in housing A (for blind
movement) or B (for sun roof movement)
and turn it clockwise to open the roof (or
the blind) or anticlockwise to close the
roof (or the blind).
INITIALISATION PROCEDURE
Following an automatic movement
malfunction while opening/closing or
after an emergency manoeuvre (see
description in the previous paragraph),
the automatic operation of the sun roof
must be initialised again.
J0A00390C
47