Table of Contents
Advertisement
1 Select Unit Configuration and then specify the Gateway IP Address and
2 If you want to use the Gateway as a DHCP Server, click in the Enable
3 Clicking Auto Range will automatically choose the largest available range
4 Check all of your settings, and then click Apply.
DHCP Clients List
The LAN Settings screen is used to specify the LAN IP address of your
Gateway, and to configure the DHCP server.
Subnet Mask in the LAN Settings field. The default IP address of the
Gateway is 192.168.1.1.
check box.
of addresses for your network.
The DHCP server will give out addresses to both wired and wireless
clients.
Figure 32 DHCP Clients List Screen
The DHCP Clients List provides details on the devices that are connected
to the LAN. The list is only created when the Gateway is set up as a DHCP
server. For each device that is connected to the LAN, the IP address, Host
Name, MAC address and Client Type of that device is displayed. As you
connect more devices to the LAN, the client list will grow to a maximum
number of clients, which is determined by the IP address range.
The Release button allows the lease time for the IP address that has been
issued to a device to be cleared. The lease time is set at 12 hours. If a PC
has been switched off, using the Release button would allow the 12 hour
lease time to be cleared. The IP address would then be available for
another device if there were no other IP addresses available.
LAN Settings
45
Advertisement
Table of Contents
