Page 1
INSTRUCTION MANUAL MODEL AG812 ACCESS GATE ♦ WARRANTY ♦ INSTALLATION ♦ OPERATION CORPORATE HEADQUARTERS EASTERN REGION U.S.A. 40355 Delta Lane 125 Wyatt Lane Palmdale, California 93551 Fredericksburg, VA 22406 Phone: (661) 575-1100 Phone: (540) 310-4050 Fax: (661) 575-1109 Fax: (540) 310-4157 Email: info@deltascientific.com...
Page 2
Products will be free from defect in material and workmanship. Delta's sole obligation under this warranty shall be to repair (or at Delta's option, to replace), FOB: Palmdale, California, any defective product, without charge to Buyer, provided that, (a) Buyer gives Delta written notice of...
1 Lane, Free In Or Free Out Entrance & Exit With Revenue Equip. Ticket Dispenser, And Kiosk Typical Ticket Dispenser/Access Gate Card In, Free Out MAINTENANCE TROUBLESHOOTING SPARE PARTS LIST Copyright 2013 Delta Scientific Corporation Page 3 of 17 All Rights Reserved Document A2021.6...
Installation The Model AG812 is packed in a reinforced cardboard carton with an inner poly bog to guard against moisture. Do not stack cartons or leave out in the elements until ready to set. Gate model number and accessories are marked on carton top.
The AG812 is to be located on a solid, non-combustible surface, such as concrete. Mark the Gate location from the architect’s drawings. Conduit for the Gate motor and controls must be brought to the stub-up area within the Gate’s bottom opening (shown above). Foundation bolt location can be marked from the Gate itself or from a template (Delta P/N D03180).
CAUTION: Do NOT manually operate gate unless power has first been turned off! There is potential for sever injury if power is restored while manually operating gate. All AG812 Gates have the capability to be manually raised or lowered. The normal method to manually raise or lower the gate arm’s position is to: Unlock the access cover.
Dart Arm (optional) The dart arm is an optional, factory-installed device that will cause the AG812 gate arm to return to the vertical (open) position if the gate arm should encounter a solid object during the AG812’s ‘close’...
Maintenance Good maintenance is essential to the long life of your Delta AG812 Access Gate. Long, trouble free operation is obtained by adhering to the following suggestions: Check belt tension every 60 days to control Gate over travel. Consistent tension will allow the gate to stop in the same position every time.
Page 16
Power Loss The Delta AG812 can be opened or closed in the event of a power outage by the following: CAUTION: Power switch should be in the ‘Off’ position when manually operating the gate to prevent hands from being caught in the drive belt pulleys if motor should happen to start if power is restored.
AG812 ACCESS GATE – SPARE PARTS 4369-01A ALUMINUM CABINET ASSEMBLY (Door Sold Separately) 4369-02A ALUMINUM CABINET DOOR ONLY 4369-03 KEY LOCK FOR CABINET DOOR 4369-04 GEAR BOX, 60:1 4369-05 MOTOR, 1/2 HP - 120/1/60 4369-05A MOTOR, 1/2 HP - 240/1/50 4369-06 SHEAVE, 2.0 O.D.
Page 19
DESCRIPTION/MATERIAL WT EA TOT WT REF NO AG812 CABINET ASSEMBLY 43.3 43.3 4369-01A AG812 CABINET DOOR LESS LOCK 4369-02A T-HANDLE DOOR LOCK AND KEY 4369-03 GEAR BOX W/CRANK ARM, 60:1 RATIO #REF! #REF! 4369-04 MOTOR, 1/2 HP, VOLTAGE AS ORDERED 12.0...