Loading The Paper - Wagner Ewar WP1300 Series Manual Instructions For Use

MANUAL ELECTRONIC PAPER ROLL DISPENSER
SERIES WP1300 / WP1400

5.4 Loading the paper:

Ernst Wagner GmbH & Co. KG
Ernst-Abbe-Straße 21 · D - 72770 Reutlingen Tel. +49 7121 515 39-0 · Fax: -20
info @ wagner-ewar.de · www.wagner-ewar.de
To load the first roll, place the plastic holders into the left and
right ends of the roll and then place the cylindrical stubs into
the holders on the back wall of the dispenser
Using the blue lever on the left side, raise the paper guide at
the front and guide the paper underneath it.
Paper is pulled in automatically and discharged by the
dispenser upon pressing the "Manual operation" button.
(The button is located under the removable spray guard and,
if necessary, can be actuated by means of the product's key).
Tear off the first piece of paper, re-attach the spray guard,
and close the dispenser door.
The dispenser is now ready for use.
It is possible to load a new roll even though the old roll as
not yet been consumed completely.
To do so, remove the old roll from the upper holder and
place it in the lower holder. Please press it down completely.
The paper guide at the front is then raised automatically.
Using the 2nd pair of holders, load the new roll as described
above. Direct the paper under the paper guide (see above)
and press it against the two sharp points on the paper guide
to secure it.
The dispenser is now ready for use, the door can be closed.
The paper on the new roll is grasped and dispensed once the
old roll is consumed almost completely.
PAGE: 23/30
DATE OF ISSUE: 2021/01