Using The Wired Remote Control; Installation - Sony DSX-GS80 Operating Instructions Manual

Using the wired remote control

When using the steering wheel remote
control
Installation of the connection cable RC-SR1
(not supplied) is required before use.
1
To enable the steering wheel remote
control, select [STEERING]  [EDIT CUSTOM]
to make the registration. When the
registration completes, the steering wheel
remote control becomes available.
Notes on installing the connection cable
RC-SR1 (not supplied)
• Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
• Depending on the type of car, be sure to insulate
the unused leads with electrical tape for safety.
• Do not connect this cable when the steering wheel
remote control is not used.
• Consulting the dealer or an experienced
technician for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set
[STRG CONTROL] in [STEERING] to [PRESET] .

Installation

Removing the mounting
sleeve
Before installing the unit, remove the trim
ring  and the mounting sleeve  from
the unit.
Pinch both edges of the trim ring
1
, then pull it out.

2 Insert both release keys  until they
click, and pull down the mounting
sleeve , then pull up the unit to
separate.


Face the hook inwards.
Mounting the unit in the
dashboard
• Before installing, make sure the catches on
both sides of the mounting sleeve  are
bent inwards 2 mm ( 3 /
32
• For Japanese cars, see "Mounting the unit
in a Japanese car".
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink
on the left side of the unit remains hot right
after use.
in).
17
GB