Advertisement
INSTALLATION
•
Unscrew the retaining screw and remove the main
assembly from the wall mounting.
•
Turn off or isolate the mains supply.
•
Feed the supply wiring through the access point in the
wall mounting.
•
Attach the mounting to the wall using a suitable mounting
method.
•
Using an allen key, remove the top and bottom diffusers.
•
Offer up the main assembly and connect the mains
supply wires to the terminal block.
•
Connect the positive supply wire (brown or red) to the
terminal marked L.
•
Connect the neutral supply wire (blue or black) to the
terminal marked N.
•
Clip the terminal block into the wall mount and refit the
main assembly onto the wall mount and replace the
retaining screw.
•
Fit 2x appropriate GU10 Max 7W lamps (not supplied)
into both top and bottom lamp holders.
•
Refit the diffusers and secure the 4 allen screws in each.
•
Restore the mains supply.
4
CLEANING AND MAINTENANCE
•
Clean only with a soft, dry cloth. Do not use any chemicals, abrasives or solvents
that may damage the product.
SPECIFICATIONS
Voltage
IP rating
Lamp type
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
5
220-240V~50Hz
IP44
2 x GU10 7W LED
2
1
6
Made in China. PR2 9PP
2
3
7
Man Rev 1.0
Advertisement
