UTEPO USP201E Quick Start Manual

Ethernet surge protector 10/100mbps

Advertisement

10/100Mbps
The product is a single channel network signal surge protector according to IEC61643-21:2000 design
standard. The device rated working voltage is 5V, the max continuous running voltage is 6V, limited voltage
less than 20V, it has multi level protection function, high capacity, low limited voltage, quickly response,
low insertion loss and so on .It is applicable for computer network signal , Hub, network switch, network
and so on as whole monitoring system accurate overvoltage protection,
overvoltage ,operating over-voltage and electrostatic discharge caused damage.

Application

The product
IP camera
UTP cat 5/5e
Grounding

Features

:
Reference standard: IEC61643-21:2000;
Protection signals: Ethernet signal,10/100Mbps;
Function : Multi function and multi level over voltage protection, high capacity, low limited
voltage, quickly response, low insertion loss;
Grounding: Extension cable directly connect with ground wire;
Appearance design: identification clearness, easy recognition, whole aluminium outer
shell, mini size, easy installation.
1
making it is safe from induced
M
o n
i t o
r
The product
UTP cat 5/5e
UTP cat 5/5e
Grounding
Panel
Grounding
Input
Grounding

Installation steps

Check the following equipment and accessories before installation if lost, please contact
your distributor
The product
User manual
Please install as following steps
1.Check grounding resistance that should meet the specification before connection the
device to system.
2. Connect protector on the front of the protected device ,it must be connected reliably.
3. Connect the device ground wire to protection ground strap keeping in the shortest
possible distance.
Note:
1.Protectors have In, Out symbol, connect output to protected device, do not take
opposite. Otherwise it will
cause the damage of the protector ,equipment also can not be protected .
2.Loss increases by bad connection socket and other factors, should reconnect or
replace protector
3. The user can not disassemble the various parts of the protector, avoid damaging,
affect the normal working.
Output
1pc
1pc
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the USP201E and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for UTEPO USP201E

  • Page 1 Panel 10/100Mbps Grounding The product is a single channel network signal surge protector according to IEC61643-21:2000 design standard. The device rated working voltage is 5V, the max continuous running voltage is 6V, limited voltage less than 20V, it has multi level protection function, high capacity, low limited voltage, quickly response, low insertion loss and so on .It is applicable for computer network signal , Hub, network switch, network and so on as whole monitoring system accurate overvoltage protection, making it is safe from induced...
  • Page 2 se口 specification Item Description Working voltage(Un) Nominal discharge current(In) Maximum discharge current(Imax) Protection level(Up) Ethernet Rate 10/100Mbps Response Time Insertion loss 0.5dB Connector RJ45 Protection circuit 1/2 3/6 4/5 7/8 Working temperature -40℃~85℃ -40℃~75℃ Environmental Storage temperature Humidity (non-condensing) 0~95% Weight 100g Mechanical...

Table of Contents