UTEPO USP2108 Quick Start Manual

Multichannel Network Signal Surge Protector
The surge protector is an 100M ethernet signal surge protector based on IEC61643-21:2000
standard. The equipment nominal voltage is 5V, maximum continuous running voltage is 6V,
limit voltage is less than 20V. It features multi-level protection, large maximum discharge
current, low limiting voltage, quick reacting time, low inserting loss etc..It is adapted to
Ethernet switch, concentrator, network card, computer signal and power over voltage
protection, exempt from the damage caused by reacting over-voltage, operating over-
voltage and static electricity discharge etc.. It is widely used in conference system, security
surveillance system etc..used in meeting system, security surveillance and office ethernet
project.
Application
IP camera
Dome camera
Feature
● Standard : IEC61643-21:2000 standard
● Protection: Ethernet signal(bandwidth ≤ 100Mbps);
● Feature: Multi-level over voltage protection, large capacity discharge current, low limiting
voltage, quick reacting time, low inserting loss;
● Grounding mode: Extending line to the ground;
● Design :Clear mark, easily recognized, aluminum shell, support desktop or on-wall installation.
Notice
1) Please make sure that the surge protector output is connected with the protected equipment.
The connection should not be reversed!
2) The surge protector doesn't work if not strictly abide by the grounding instructions .
1
Switch
Multichannel Ethernet
Signal Surge Protector
Surge protector
;
Multichannel Ethernet Signal Surge Protector
Board Diagram
8Channel Ethernet Signal Surge Protector
Front board
Signal input
IN (Line)
OUT (Equip)
Signal output
24Channel Ethernet Signal Surge Protector
Front board
IN(Line) IN(Line)
OUT(Equip) OUT(Equip)
Back board
Installation Step
Please check the following items before installation, if it s missing please contact the dealer.
Multichannel ethernet signal surge protector
Hanger
User manual
Please follow the installation step
1) Before inserting protector into system, please make sure the grounding grid reach the
standards;
2) Please ensure that the connection is stable;
3) Please ensure that the grounding cable of surge protector is connected with the main grounding
cable in the room as short as possible.
Notice
1)Protector possess signs of input(IN), output(OUT). Please ensure that the output end is
connected with the protected equipment, otherwise it will cause the damage of surge protector.
2)Please check the plug if the consumption increases. You can either re-connect it or replace the
protector.
3) Please don't un back the component personally
Back board
Signal input
IN(Line) IN(Line) IN(Line)
OUT(Equip) OUT(Equip) OUT(Equip)
Signal output
Grounding
'
1pc
1pair
1pc
Grounding
2