Page 1
Apex Spotlights Product information The new spot range has been designed to fix all the frustrations that electricians face with current spot lights. The 2 part easy-connect base installs onto the wall or ceiling with plenty of space for cable termination with entry from back or base (20mm conduit) and the body of the light uses custom guides to slide onto the base perfectly making solid cable-free connections with the pin terminals.
Page 2
INSTALLATION GUIDE Disconnect mains before proceeding! Remove lamp from the box, unscrew and remove the base cover in the centre of the fitting. Screw Guide Pull the cable through the cable hole (either penetrate the rubber cap or break away the bottom knock out and use appropriate sealant to retain IP protection).
Page 3
OPTIONAL FOR SENSOR VERSION: DUAL AXIS SENSOR: Vertically 145° Horizontally 340° Use flathead screwdriver to adjust knobs for Time, Lux and Sensitivity. Adjust horizontally or vertically - Do not rotate! SETTING THE CONTROLS SEQUENCE 1. Turn the Lux control knob to light (sun) position, turn the wall switch on and wait half a minute for the control circuit to stabilize. At this stage ensure that the TIME control knob is set at minimum.
Page 4
PLEASE NOTE MUST BE INSTALLED BY A LICENSED ELECTRICIAN • Read instructions carefully before attempting to install the fitting. Retain this guide for future reference • Disconnect power before installing or servicing • This fitting is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures •...
This manual is also suitable for:
Ml-apexs-m-blMl-apexs-m-whMl-apexssn-m-blMl-apexssn-m-whMl-apexd-m-blMl-apexd-m-wh...
Show all