Advertisement
PLEASE NOTE
MUST BE INSTALLED BY A LICENSED ELECTRICIAN
•
Read instructions carefully before attempting to install the fitting. Retain this guide for future reference
•
Disconnect power before installing or servicing
•
This fitting is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures
•
Do not extend low voltage cables from the output of power supply
•
All components must not be mechanically stressed
•
Be careful not to damage or destroy conductive paths on the circuit board
•
Follow all relevant electrical and safety standards (including AS3000)
•
Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered under warranty
•
Damage by corrosion will not be honoured as a material defect claim. It is the user's responsibility to provide suitable protection against
corrosive agents such as moisture, condensation and other harmful elements
T. 1300 222 445 | www.melec.com.au
For further information about our Warranties please go to: melec.com.au/legal/warranties
Advertisement
