Advertisement
INSTALLATION GUIDE
Disconnect mains before proceeding!
Remove lamp from the box, unscrew and remove the
1.
base cover in the centre of the fitting.
2.
Pull the cable through the cable hole (either penetrate
the rubber cap or break away the bottom knock out and
use appropriate sealant to retain IP protection).
Mount the base using the required screw guides.
Wire up the light in accordance with the marked
3.
terminals:
N - Neutral
L Out - Load out from sensor*
L - Line In
*L - Out is used to conect other lights to the sensor
(optional, max load 70W inc fitting draw)
Unscrew Sensor out tab if required.
Ensure cables are tidied in the cable space area on the
left (not on the right).
4.
Set the desired colour temperature (WW / NW / W)
on the switch inside main body.
5.
When installing the main body back to the base make
sure, the locating pins on main body go into the slots on
the base. Once installed, secure the main body onto the
base with the screw that you removed in step 1.
T. 1300 222 445 | www.melec.com.au
Screw Guide
Rubber Cap
Knock Out
Cable Space
For further information about our Warranties please go to: melec.com.au/legal/warranties
Screw Guide
Screw Guide
Screw Guide
Sensor OUT
Advertisement
