Connecting To An Audio System Equipped With Analog Audio Inputs - Toshiba SDP93SWN Owner's Manual

CAUTION
• When you are connecting (via the BITSTREAM/PCM
jack) an AV decoder that does not have Dolby Digital,
DTS or MPEG2 decoding function, be sure to set
"Digital Out" to "PCM" from the on-screen displays
Otherwise, high volume sound may damage your hearing
as well as the speakers.
• When playing DTS-encoded discs (audio CDs), excessive
noise may be output from the analog audio output
jacks. To avoid possible damage to the audio system,
you should take proper precautions when the analog
audio output jacks of the player are connected to an
amplification system. To enjoy DTS Digital Surround
playback, an external 5.1 channel DTS Digital Surround
decoder system must be connected to the BITSTREAM/
PCM jack of the player.
Note
• DO NOT connect the BITSTREAM/PCM jack of the player to
the AC-3 RF input of a Dolby Digital Receiver. This input on
your A/V Receiver is reserved for Laserdisc use only and is
incompatible with the BITSTREAM/PCM jack of the player.
SDP93SWN-E_57-88.indd 69 SDP93SWN-E_57-88.indd 69
Connecting to an audio system equipped
with analog audio inputs
62 .
To AV OUT
®
Audio/video cable
®
(supplied)
Setting
Make the
following setting.
"Digital Out"
Signal flow
To analog audio inputs
Red (Right)
AUDIO IN
Audio system
R
L
White (Left)
Yellow (Video)
No need to connect.
Select: Page
62
"Analog 2ch"
69
2009/01/19 13:00:55 2009/01/19 13:00:55