Before Calling Service Personnel - Toshiba SD-P1750SN Owner's Manual

Before calling service personnel

Check the following guide for the possible cause of a problem before contacting service.
Symptom Cause
No power. • The AC adapter or power plug is
disconnected.
• The battery pack has been removed.
• Battery empty.
The LCD turned off by • The automatic LCD off function turned
itself. the LCD off.
No picture. (Other than • The connected TV is not set to receive
built-in LCD monitor) DVD signal output.
No sound. • The equipment connected via the
audio/video cable is not set to receive
DVD signal output.
• The volume is too low.
• The audio receiver or TV is turned off. • Turn on the equipment connected with the audio/video cable.
• The setting of output sound format is
incorrect.
The playback picture has • The disc is dirty.
occasional distortion.
• Player is in fast forward or fast reverse
mode.
• The player was moved or given a
shock.
• The disc is not set fi rmly.
Brightness is unstable or • The effect of copy protection. If you
noises are present in the connect the player to a VCR, TV/VCR
playback pictures. (Other combination or video selector, the
than built-in LCD monitor) playback picture may be distorted as
DVD video discs are copy protected.
SD-P1750SN-E_P53-84.indd 71 SD-P1750SN-E_P53-84.indd 71
Correction
• Connect the AC adapter or power plug securely.
• Install the battery pack.
• Re-charge the battery.
• Turn on the player again.
• Select the appropriate video input mode on the TV so the picture from
the player appears on the TV screen.
• Select the correct input mode of the audio receiver so you can listen
to the sound from the player.
• Adjust the volume by turning the volume control.
• Select the proper audio setting.
• Eject the disc and clean it.
• Sometimes a small amount of picture distortion may appear. This is
not a malfunction.
• Vibrating or shaking the player during playback may produce
distortion. This is not a malfunction. If not restored to usual status,
stop playback and start again.
• Remove the disc and set it again.
• Connect the player directly to the TV. Avoid connecting the player to a
VCR or TV/VCR combination.
71
07.1.17 11:20:26 PM 07.1.17 11:20:26 PM