Toshiba DR570KU Owner's Manual page 58

DVC to DVD Dubbing (cont'd)
5
Press [PLAY B] to start playing back
the DVC, and find the point where
you wish to start dubbing.
Then, press [STOP C] when you come
to the desired start point.
6
Use [K / L] to select "Start Rec", then
press [ENTER].
The dubbing will start.
7
To stop dubbing;
Use [K / L] to select "Control", then
press [ENTER].
Use [K / L] to select "DVD", then
press [ENTER].
Then press [STOP C].
Note for DV dubbing
• If you press [PAUSE F] at step 5, the tape will rewind to the point a few seconds preceding the paused point.
When you press [ENTER] at step 6, then, it will start dubbing when it comes to the paused point.
• The unit does not send out the output signal to DVC.
• For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.
• Do not connect more than 1 DVC.
• The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognized.
• If no video signal is detected from the DVC during DVC to DVD dubbing, the recording will be paused and "I" will
flash on the TV screen. The recording will resume when the unit detects the video signal again.
• When the DVC is in camera mode, refer to "Guide to DV and On-Screen Display" on page 56.
• You cannot dub from DVC during timer standby mode.
• Date / time and cassette memory data will not be recorded.
• Pictures with a copy-guard signal cannot be recorded.
• A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called "Fire
Wire". It serves as the interface that connects the PC and peripheral device such as "i.LINK" (registered trademark
of SONY). It enables digital dubbing between DV devices with little degradation.
58 58 EN EN
E7SC0UD_D-R570KU_EN_v1.1.indd 58 E7SC0UD_D-R570KU_EN_v1.1.indd 58
DV DUBBING
2009/04/06 11:17:49 2009/04/06 11:17:49