Table of Contents
Advertisement
- Protective goggles
- Heavy gloves
- Hearing protection
OPERATING SAFETY
1. Read and understand the Operator's Manual and all safety signs before using.
2. Attach securely to towing unit using a pin with a retainer.
3. Do not exceed a safe travel speed.
4. Use hazard flasher on towing unit when transporting.
5. Review safety instructions annually.
MAINTENANCE SAFETY
1. Follow good shop practices:
- Keep service area clean and dry.
- Be sure electrical outlets and tools are properly grounded.
- Use adequate light for the job at hand.
2. Use only tools, jacks, and hoists of sufficient capacity for the job.
TRANSPORT SAFETY
1. Read and understand ALL the information in the Operator's Manual regarding procedures
and SAFETY when operating the swath roller in the field and/or on the road.
2. Always travel at a safe speed. Use caution when making corners or meeting traffic.
3. Make sure the reflectors required by the local highway and transport authorities are in place,
are clean and can be seen clearly by all overtaking and oncoming traffic.
Note: The slow-moving vehicle sign and flashing lights on the swather must be visible from
behind when the MT3000 is secured in the transport position.
4. Be sure that the TB2000 is hitched positively to the towing vehicle and a retainer is used
through the drawbar pin. Be sure that the MT3000 is secured properly with both transport
locks and the pins are secured.
5. Keep to the right and yield the right-of-way to allow faster traffic to pass. Drive on the road
shoulder, if permitted by law.
6. Do not exceed 32 km/h. (20 mph). Reduce speed on rough roads and surfaces.
5
Advertisement
Table of Contents
