Mercedes-Benz AMG GT Roadster Operator's Manual page 155

Hide thumbs Also See for AMG GT Roadster:
Table of Contents

Advertisement

%
In this phase you can adjust RACE START
depending on the road conditions: you can
vary the engine speed by pulling on one of
the steering wheel paddle shifters. The seg‐
ments in the multifunction display flicker
rapidly.
%
If the brake pedal is not released after a
short while, RACE START is canceled. The
RACE START Canceled
message appears in
the multifunction display.
Take your foot off the brake, but keep the
#
accelerator pedal depressed.
The vehicle pulls away at maximum accelera‐
tion. The
RACE START Active
message
appears in the multifunction display.
RACE START is deactivated when the vehicle rea‐
ches a speed of approximately 31 mph
(50 km/h).
RACE START is deactivated immediately if you
release the accelerator pedal during RACE
START or if any of the activation conditions are
no longer fulfilled. The
RACE START Canceled
message appears in the multifunction display.
%
After using it several times in short succes‐
sion, RACE START is unavailable until a cer‐
tain distance has been driven.
Function of the AMG steering-wheel buttons
The AMG steering-wheel buttons include two
additional control elements on the steering
wheel.
You can assign two vehicle functions of your
choice to the left control element. You can
change between the available functions by
pressing display buttons
2
repeatedly. The cur‐
rently selected functions are displayed in display
buttons 2.
Driving and parking 153
The following functions are available:
®
ESP
(
page 139)
R
/
AMG adaptive sport suspension system
R
(
page 155)
/
AMG Performance exhaust system
R
(
page 116)
/
ECO start/stop function (
page 115)
/
R
Manual gearshifting (
page 125)
/
R
Rear wing (
page 154)
/
R
Front and rear view camera (
/
R
If you have assigned a function to one of display
buttons 2, you can operate this function with
corresponding button 1.
The assignment of display buttons
2
stored even after a new engine start, but the
operating status of the respective function is
reset to the basic setting.
You can change between the drive programs
with stabilizer bar actuator 3. The selected
drive program appears in display button 4. By
pressing display button 4, you can directly
page 158)
remains

Advertisement

Table of Contents
loading

Table of Contents