Heatilator NNXT33-IFT Owner's Manual page 15

- Wait five (5) minutes to allow possible
accumulated gas to clear.
- Set the IFT-ECM 3-position selector switch to ON
or REMOTE position. Module will beep once and
flash a three GREEN LED code on successful
startup.
- If placed in ON position, the appliance will ignite
normally if the error condition was corrected.
- If placed in REMOTE position, use the paired IFT-
RC400, IFT-RC150 or wired wall switch to start
the appliance; appliance will ignite normally if the
error condition was corrected.
- If the IFT-ECM re-enters the lock-out condition
after these steps, call your dealer for service.
Heatilator • NNXT33-IFT, NNXT33L-IFT, NNXT36-IFT, NNXT36L-IFT Owner's Manual • 2628-981 Rev. D • 1/21
Appliance ON/OFF:
Use the factory-installed IntelliFire Touch RC400 Remote
Control to control the ON/OFF function of the appliance.
Follow the instructions included with the appliance remote
control for more information.
If desired, a wall switch may be installed to control the
ON/OFF function of the appliance.
Fan ON/OFF:
The fan may be turned on and off and the speed adjusted
by the remote control that comes standard with the fire-
place. Consult the instructions included with the appli-
ance remote control for more information.
Wi-Fi (Optional)
if desired, a Wi-Fi module (IFT-WFM) may be added to
allow the appliance to be run via an app. Contact your
dealer to order.
15