Toro 20961 Operator's Manual page 18

Figure 23
2. Ensure that the cutting-height setting on the
machine is 35 mm (1-3/8 inches) or higher; if
it is not, raise it; refer to
Height (page 10).
3. Disengage the handle locks
Figure 24
1. Handle lock engaged
position
4. Fold the handle fully forward
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
decal133-8198
Adjusting the Cutting
(Figure 24).
g189218
2. Handle lock disengaged
positions
(Figure 24).
(Figure 25).
17
Figure 25
g189217