ThermoPro TX-4B Instruction Manual

Wireless outdoor humidity and temperature monitor

WIRELESS OUTDOOR HUMIDITY AND TEMPERATURE MONITOR

Introduction

Congratulations on your purchase of the wireless outdoor humidity and temperature monitor. You will now be

able to know the outdoor temperature and humidity while sitting inside.

2. One remote sensor (Transmitter)

* Although the remote sensor is designed to be rain-proof, it still must be always put in a dry place to

avoid direct rainfall.

Rain-proof and

wall-mounted

Outdoor Temperature range: -58°F ~ 158°F (-50 °C ~ 70 °C)

Humidity range: 10% ~ 99%

CHANNEL Selector (1,2,3): Slide to set Channel 1,2 or 3.

RESET: Press once to reset the remote sensor.

INSTRUCTION MANUAL

Model No. TX-4B

design

Table of Contents

Do you have a question about the TX-4B and is the answer not in the manual?

Page 1 WIRELESS OUTDOOR HUMIDITY AND TEMPERATURE MONITOR INSTRUCTION MANUAL Model No. TX-4B Introduction Congratulations on your purchase of the wireless outdoor humidity and temperature monitor. You will now be able to know the outdoor temperature and humidity while sitting inside. Components 2.
Page 2 4. The base station and remote sensor can both be wall mounted. Synchronize Remote Sensors with The Base Station ThermoPro TX-4B Universal Waterproof Transmitter Monitor Temperature and Humidity Outdoor Sensor , Compatible with TP63B/TP67B/TP68B/TP65B Series Indoor Outdoor Thermometer 1. Place the remote sensor near the base station;...
Page 3 turn on the outdoor sensor 2. press and hold the “CH/ON/OFF” button for 3 seconds to 3. Press the ON/OFF/CHANNEL button (on the back of the remote sensor unit) to dispaly 1 or 2 or 3. The unit is pre-set Channel 1 and you can always leave it unchanged unless you have purchased more than 1 remote sensor.
Page 4 l) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.