Viewing The Digital Signal Meter; Setting The Time Zone; Viewing The System Status; Reset Factory Defaults - Toshiba 19CV100U Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1
From the Setup menu, press
select Installation and then press
2
to highlight Terrestrial, and
Press or
press or to select Signal Meter and
then press .
3
Press
and digital channel whose signal you want to
check.
Note:
The physical digital channel number
•
listed in the Signal Meter screen may not
correspond to a virtual TV channel
number. Contact your local
broadcasters to obtain the RF channel
numbers for your local digital stations.
The signal strength does not change
•
between virtual channels on the same
physical channel.

Setting the Time Zone

The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the
correct time zone information for your viewing
area.
To set the time zone:
1
From the Setup menu, press
select Installation and then press
2
Press or to highlight Terrestrial, and
press or to select Time Zone and then
press .
3
Press and then
4
Highlight Done, and then press
After the time zone has been set, you will be asked
to set the current Daylight Saving Time status.
To set the Daylight Saving Time Status:
1
to select Yes or No, highlight
Press or
Done, and then press
32
Chapter 5: Setting up your TV
or to
.
to select the antenna input
or to
.
or to select the region.
.
.

Viewing the system status

1
From the Setup menu, press
select Installation and then press
2
Press or to highlight System Status,
and press or
Information and then press
3
Press or to scroll through the menu bar to
select Support Information and view the
related information.

Reset Factory Defaults

1
From the Setup menu, press
select Installation and then press
2
Press or to highlight System Status,
and press or
Information and then press
3
Press or to scroll through the menu bar to
select Factory Defaults.
4
Enter your PIN code (or 0000 if no PIN code
has been set).
5 Highlight Yes and then press
turn off automatically after a few seconds.
After the TV turns off, unplug the TV power
cord and then plug it in again to complete the
reset process.
To cancel the reset:
Highlight No and then press
or to
.
to select System
.
or to
.
to select System
.
. The TV will
.