Table of Contents
Advertisement
Available languages
Available languages
•
In case of contact with battery acid, thoroughly drain the affected area with running water.
Rinse out and seek medical attention immediately.
•
Remove metal and jewellery from the body during use.
•
The clamps must not touch each other or the same metallic object.
•
Always connect the red terminal to the positive battery connection first.
•
Do not connect the black terminal to the negative battery connection, but to a non
the moving metal part of the vehicle.
•
Carry out the auxiliary starting procedure only in safe, dry and well-ventilated places.
•
Monitor the compressor pressure indicator during use.
Work lamp
•
Set the work lamp switch on the front to ON.
•
The 5 LEDs light up.
•
Set the switch to OFF when not in use.
Battery status indicator
•
Press and hold the battery status indicator button.
•
The voltmeter indicates the battery status.
•
13 - 15 Volts: Ready for operation.
•
12 Volt: Charging required.
•
Below 12 volts: Charge immediately.
Charging the Power Pack
Alternating current (AC)
1.
fully charge the unit before first use.
2.
make sure that the correct power source is selected (110 volts or 230 volts).
3.
use only the supplied cables for charging.
4.
leave the unit switched off during charging.
5.
plug the mains plug into a socket and the other end into the AC/DC input socket.
6.
charging will take approximately 34 hours.
Do not exceed 48 hours charging time.
Direct current (DC)
1.
leave the appliance switched off during charging.
2.
insert the 12-volt charging cable into the cigarette lighter socket and the other end into the AC/DC
input socket.
3.
full charging takes approx. 12 hours.
Do not exceed 24 hours charging time.
Compressor
•
Open the compartment on the back and remove the air hose. Make sure that the nozzle lever
points upwards.
•
Attach the valve adapter to the valve of the rubber tires and tighten the valve adapter lever to the
push the lock downwards.
•
Set the compressor switch on the front to ON.
•
Monitor the pressure indicator during inflation.
•
When the required pressure is reached, turn off the compressor and remove the hose.
12 Volt DC Output Jack
•
Remove the protective cover.
•
Connect the 12-volt consumer.
•
When fully charged, the power station can connect a 12-volt consumer (e.g. black and white TV),
hand lamp) for approx. 4 hours. A mini cooler approx. 3 hours, as well as a
portable vacuum cleaner and a coffee machine about 1 hour.
The supply times can be adjusted according to the power requirement of the consumer.
vary.
14
Advertisement
Table of Contents
