Chapter 6: Setting Up Your Tv; Selecting The Menu Language; Configuring The Antenna Input Sources - Toshiba 56MX195 Owner's Manual

6
Setting up your TV
For menu navigation instructions, see Chapter 4.

Selecting the menu language

You can choose from three different languages (English, French
and Spanish) for the on-screen display of menus and messages.
(The TV Guide On Screen ™ menus are in English, regardless of
the language selected in this menu.)
To select the menu language:
1. Press MENU and open the Preferences menu.
2. Highlight Menu Language and press •.
3. Press y or z to select your preferred menu language and
press ENTER.
Preferences
English
Favorite Channels
Closed Caption Mode Off
Français
Closed Caption Advanced
Español
Input Labeling
Menu Language English
Home CH Setup
Navigate Select CH RTN Back EXIT
4. Press EXIT to close the Preferences menu.
46
Exit
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Configuring the antenna input
sources
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval 2 Sec
Navigate Back
Select CH RTN EXIT
3. Open the Terrestrial menu, highlight Input Configuration,
and press ENTER.
Note: The Terrestrial menu may not be accessible (items will
be "grayed out") in some instances (for example, if a cable
box is connected to the ANT 1 input or if one of the VIDEO
modes is the current input during TV Guide On Screen™
setup).
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate Select CH RTN Back EXIT
4. Press x or • to select the input source (Cable or Antenna)
for the ANT 1 input on the TV.
Note: If a cable box is connected to the ANT 1 input during
TV Guide On Screen™ setup, the entire Terrestrial menu will
not be accessible, including the input source for ANT 1, which
will automatically display "Cable Box. "
5. Press z and then x or • to select the input source (Cable
or antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
Input Configuration
Antenna 1 In Cable
Antenna 2 In Antenna
Cancel Done
6. To save your new settings, highlight Done and press
ENTER. To revert to your original settings, highlight
Cancel and press ENTER.
Exit
Exit