SPECIFICATIONS Item Specification Reception channels TV— VHF: 2 ~ 13 ch UHF: 14 ~ 69 ch RADIO— FM: 88~108 MHz AM: 530~1710 KHz Power voltage DC 6.0 V Power consumption Approx. 3.5 W Current consumption Approx. 580 mA Battery life (with alkaline batteries) Approx.
DISASSEMBLY 1. Remove the battery case. 2. Remove the three screws and the lower case. 3. Remove the three knobs. 4. Remove the screw and resolder the two wires for the speaker. 5. Remove the PCB ass'y. — 5 —...
ADJUSTMENT Items to Be Adjusted Item Measuring Instrument VCC2-1 voltage setting Voltmeter Video detection coil adjustment TV signal generator, pattern generator, oscilloscope, low-pass filter AFT coil adjustment Sweep generator, oscilloscope, voltmeter Contrast adjustment TV signal generator, pattern generator, oscilloscope Tint adjustment TV signal generator, pattern generator, oscilloscope AGC adjustment TV signal generator, pattern generator, IF levelmeter...
Page 9
IF Pad TP7(CP204) TP2(CP201) TP4(CP217) TP3(CP218) TP8(CP320) TP5(CP323) TP6(CP311) TP1(CP113) Bottom View Equipment Connection / Adjustment Procedure VCC2-1 Voltage Setting EV-2500 16-169 Voltmeter Output Input Input Input Output Output Adjust Result Connection Point Signal Connection Point Adjust to obtain a 4.50 ± 0.02 V VR100 Voltmeter reading on the voltmeter.
Page 10
Video Detection Coil Adjustment * Desolder the IF pad to open. EV-2500 Pattern Signal generator generator Oscilloscope Low-pass filter Input Output Input Input Input Output Output Adjust Result Connection Point Signal Connection Point Pattern Color bar generator Low-pass filter Adjust to obtain the minimum 45.75 MHz T200 Oscilloscope...
Page 11
Tint Adjustment * Desolder the IF pad to open. Pattern Signal EV-2500 generator generator Oscilloscope CP204 Input Output CP717 Input Input Input Output Output Adjust Result Connection Point Signal Connection Point Adjust VR301 so that the Pattern Color bar difference Pulse A Pulse B generator...
Page 12
Vcom Adjustment * Place a photo diode on the middle of the display plate. Photo sensor amp. EV-2500 Oscilloscope Photo Bandpass diode filter AV-C1 Audio/Video jack Input Input Input Output Output Adjust Result Connection Point Signal Connection Point Photo sensor Adjust to obtain the minimum amp.
IC AND TRANSISTOR LEAD IDENTIFICATION IC/LSI IC200 IC270 M51348FP BA10358F IF AGC OUT IF AGC ADJ OUT1 IF AGC IN SyOUT –IN1 OUT2 RF AGC SyIN +IN1 IN2– AGCDL AFTC IN2+ VCCv IFIN IC600 NJM2070M IFIN VIDEO GNDv VCCs SIFOUT SIFIN –IN GNDs...
SCHEMATIC DIAGRAMS IF Pad 14 15 Notes: 1. All resistance values are indicated in "ohms" (k=10 ohms, M=10 ohms). µF). 2. All capacitance values are indicated in "µF" (p=10 3. All inductance values are indicated in "µH." — 27 —...
Page 29
RADIO Notes: 1. All resistance values are indicated in "ohms" (k=10 ohms, M=10 ohms). µF). 2. All capacitance values are indicated in "µF" (p=10 3. All inductance values are indicated in "µH." — 28 —...