Programming, Configuring And Updating - Collective Minds Cronus Zen User Manual

Connecting Your ZEN to a PC
Gamepacks, GPC Scripts, Mouse and Keyboard profiles and Macros are created, downloaded are
programmed using Zen

Programming, Configuring and Updating

1. Download and install Zen Studio
2. Connect the Zen PROG port to computer with the provided micro-USB cable:
The first time the Zen is connected to the computer, the computer will detect a new USB device
and automatically install the device drivers.
3. Run Zen Studio, the software should automatically detect your Zen. Zen Studio is the main
tool for programming, configuring and developing for the Zen Device.
Please refer to the ZEN STUDIO online user manual for further instructions.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC's RF Exposure guidelines, This equipment should be installed and operated with
minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Studio.
FCC ID: 2AEVW-CM00053