Advertisement
Step #1
Spread open the flange of the hinge
mounting post and slide it down over
the right side panel until the bottom
edge of the hinge post and the bottom
edge of the side panel are even.
Step #4
Spread open the flange of the latch
mounting post and slide it down
over the left side panel. Slide the
post up or down until the support
knob closes properly into the recess
on the post. Once the latch post is
aligned so the gate closes properly
fasten the post to the side panel
using six (6) #10 x 1-1/4" screws.
Step #6
Close the gate and align the latch bar by locking it
into the gate latch as shown. Secure the latch bar
to the gate with two (2) #10 x 1-1/4" screws.
Step #7
The PES-G includes a gate closer. Mount the
closer on the flat recessed are on the hinge post
(see diagram to left).
To adjust tension on the closer after
installation see detailed instructions on closer
package.
Note:
Spraying the gate hinges with a silicone spray will aid in the self-closing action.
WARNING: GATE MUST BE LOCKED WHEN POOL IS NOT IN USE.
Step #2
With a cordless drill, fasten the hinge
post to the side panel using six of the
#10 x 1-1/4" self-tapping screws at
the pre-marked spots on each side of
the hinge post (3 per side).
WARNING!
Using a
corded drill
near pool
may result in
electrocution.
Step #3
Slide the open gate hinge through the
hinge post pin opening and wrap the
gate hinge around the hinge pin. Fasten
the hinge at the four pre-marked spots
using the #7 x 1/2" self-tapping screws
(4 per hinge).
Step #5
Install the latch on the
mounting block located
on the upper portion of
the latch post using four
(4) #10 x 1-1/4" screws.
DO NOT use the slide plate.
It is for metal/wood finish wear and will
not work with our gravity hinge.
3
Advertisement
