Toshiba JK Series Instruction Manual page 18

RECEIVING, INSPECTION AND HANDLING
Care and caution should be used when handling
the power cell to avoid damage to the equipment
and personal injury. Always keep the cell in a
generally upright position.
WITHDRAWABLE CONTACTOR CARRIAGE
HANDLING
Withdrawable contactor carriages are shipped
inside their respective power cells. During initial
installation by the OEM, the contactor carriage
must be removed from the cell to allow access
for anchoring the cell to the enclosure, for
connecting cables, etc.
Removal of the contactor carriage may be
accomplished by the use of an optional Toshiba
JK carriage lifting
#LCV5010H20G01) and a suitable overhead
lifting device. The use of the lifting device is
illustrated in Fig. 16.
DRAWER
BASE
attachment (JK Yoke
LEFT
Fig. 16 Contactor Carriage Lifting Attachment
Two shipping brackets securing the carriage to
the service drawer must be removed before
attempting to lift the carriage from the drawer.
These brackets are used only for transportation
and may be discarded.
To attach the lifting attachment to the carriage:
1. Position lifting attachment on top of carriage.
2. Swing side support arms down to meet
carriage base.
3. Securely screw lift bolts into base.
4. Attach overhead lifter to eye bolt on top of
lifting attachment and lift from drawer.
WARNING
SIDE
SUPPORT
ARM
LIFT
BOLT
SHIPPING
BRACKET
(REMOVE BEFORE
LIFTING FROM
DRAWER)
Page 14
Maximum weight of
carriage is 135 lbs.
equipped with double
barrel fuses. Verify that
lifter used has adequate
load capacity.
ATTACH OVERHEAD
LIFTER HERE
FRONT