Caster Assembly; Carry Handle Assembly - RIDGID WD10500 Owner's Manual

Caster Assembly

WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
1. Turn the dust drum upside down on
the floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown (4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.

Carry handle Assembly

1. Place the carry handle on the Wet/Dry
Vac power head assembly.
2. Tighten both screws to assemble the
carry handle on the power head
assembly.
5
Caster
Caster
Stem
Caster
Socket
Drum
Screw (2)
Carry
Handle
Power
Head
Assembly