Cleaning The Cooling Module - Toshiba M10-S3401 User Manual

230
TOSHIBA PC Health Monitor
Enabling the TOSHIBA PC Health Monitor

Cleaning the cooling module

The following information is dependent on if access to the cooling
module is available. Access is available on certain models only.
NOTE
To clean the cooling module, follow the steps detailed below:
1 Shut down the computer and make sure the Power indicator is
off (refer to
Getting Started chapter, if necessary).
2 Remove the AC adaptor and all cables and peripherals
connected to the computer.
3 Close the display panel and turn the computer upside down.
4 Remove the battery pack (refer to
the computer" on page 119
if necessary).
5 Depending on your model, use either a thin-tipped tool to push
the hole at the edge of the cooling module cover, or a
screwdriver to remove the screw, and then slide the cover in the
direction of the arrow to remove it.
(Sample Illustration) Removing the cooling module cover
If you use the computer for a long period, the inside of the computer
may become hot. Always allow the computer to cool to room
temperature before you clean the cooling module.
"Turning off the computer" on page 78
Cooling module
cover
"Removing the battery from
in the Mobile Computing chapter,
in the
Hole or screw
(depending on
your model)