Advertisement
2. Attaching the mount head
2.1 Place the mount head onto the tripod.
2.2 Use the central rod between the three tripod legs to screw the mount head tightly onto the tripod. Make sure the
washer at the top of the central rod is flush with the tripod.
Reproduction of part or all of the contents of this document in any form is expressly prohibited other than for individual use only. All text, images and labels are property of Nimax Gmbh.
How to assemble the mount?
1. Preparing the tripod
1.1 Loosen the clamps for the tripod legs. Slide out the leg extensions
and re-tighten the clamps.
1.2 Spread the three tripod legs to give it a wide and stable stance.
1.3 Remove the black spreader knob from the central rod.
Tip:
Extend the tripod legs by varying amounts for
your desired tripod height or to offset uneven
terrain.
Attention: The azimuth adjustment screws on the
underside of the mount head must be extended
before attaching the mount head! Extend them far
enough to give enough space for the protruding
knob on the top of the tripod.
Advertisement
